Winter plumbing

Frozen Pipe or Burst Pipe? What to Do Before the Plumber Arrives

Decide what to do when a tap stops flowing during a freeze, a suspected frozen pipe is inaccessible, or water has started leaking.

PlumberPick
PlumberPick
Illustration accompanying the emergency plumbing leak action plan

Check whether water is already escaping

If you can see or hear uncontrolled water, treat it as an active leak. Shut off the household water supply if you can safely reach and operate its valve. In an apartment, tell the building emergency contact right away because the line may be shared. Keep away from standing water near electrical equipment and call for emergency help from a safe place if there is electrical danger.

If one tap has stopped or slowed sharply during a freeze, record whether the hot side, cold side or both are affected and whether nearby fixtures still work. A freeze is possible, especially along an exterior wall or in an unheated area. If the whole building has lost water, also check with the utility or building manager for a supply interruption.

Who to call when water stops or starts leaking
SituationFirst call or action
Water is escapingIsolate water if safe, then contact emergency plumbing or building maintenance.
One tap has low or no flowRecord which sides and fixtures are affected. Look for visible water from a safe location.
Suspected pipe is behind a wallCall a plumber. Avoid opening finishes or applying heat blindly.
Several units or the whole house have no waterCheck for a building or utility outage while arranging help if needed.

Map the outage without disturbing pipes

Start with one nearby fixture. Does the bathroom cold tap run while the kitchen cold tap has stopped? Is the hot side of the kitchen working? These observations help dispatch decide how the problem might be distributed. Write down when flow was last normal and whether the home or an affected room was unusually cold overnight. Keep the checks to ordinary tap use and visible areas.

If both hot and cold flow are gone throughout the building, ask the building manager or water utility about work or an interruption. If an outdoor tap or line beside an exterior wall stopped first, tell dispatch where it sits in relation to the heated space. An isolated fixture can have causes other than frozen pipework. Describe what you can observe and let the plumber confirm the cause.

Example: the kitchen cold tap stopped overnight, the hot side still runs, and the adjacent utility room also feels cold. Note which other fixtures are normal and photograph the accessible cabinet or route without taking panels apart. If two neighbouring flats lost water at once, send that information to management instead of treating the same clues as a private-line repair.

Know which shutoff you are allowed to use

If active water is escaping, the safest useful action may be to stop the supply using an accessible household shutoff. In a rented home or multi-unit building, ask management for the correct on-call number and the location of the shutoff serving your unit. Keep people away from contaminated or electrically hazardous water. Get immediate help if reaching the valve would put you at risk.

An old valve may be stuck or hard to identify. Tell the plumber where you think it is and what is preventing safe operation. Avoid forcing it, entering a utility pit or operating shared equipment when you are unsure who it serves. The American Red Cross guidance also covers what to do when the frozen section cannot be found or safely reached.

Once flow is isolated, tell everyone who needs to know that the water is off and ask the plumber how restoration will be handled. In a building with a leak spreading downstairs, notify management and any affected neighbour where it is safe to do so. Record when you noticed the first signs and when supply was shut off.

Plan for what happens as it warms

Keep the likely shutoff accessible and stay where you can monitor the affected area. A split can be hidden while water is frozen, then start leaking as it thaws. For an accessible frozen pipe without a suspected split, the American Red Cross frozen-pipe guide explains the role of an open faucet and gentle heat. Keep flames away from pipes. If the pipe is damaged, inaccessible or you can’t locate the freeze, let a licensed plumber handle it.

Look for new staining, drips, damp flooring or a sound of running water as temperatures rise. If water starts escaping, switch to the active-leak steps. Use the emergency leak action plan for isolation and the handoff to the plumber.

Check what happens when flow returns

When a warmed line starts flowing again, watch from a safe position for dripping, a new stain or water spreading along a floor or ceiling. Ask the plumber to confirm when and how the supply can be turned back on if it was isolated. A loss of flow can ease before hidden damage becomes obvious, particularly when the failed section is behind a finish.

Document damage once the situation is under control. Take a wide photo of the room and close shots of visible effects. Tell your insurer or building manager what actions have already been taken, and keep receipts for emergency work. If the affected surfaces are extensive or there is a ceiling bulge, ask for professional assessment before entering or working below them.

If a plumber restores water on the first visit, ask what was checked, which parts of the run were accessible, and what signs warrant calling back. A repaired pipe and drying or restoring floors and walls often involve different work. Agree who checks, dries and repairs any wet areas before you book follow-up work.

Give dispatch enough detail to prioritise the call

Try: “After last night’s freeze, the cold side of the kitchen tap stopped flowing. The bathroom still works. The kitchen is on an exterior wall and the pipe is inside a cabinet. I can reach the main shutoff and haven’t seen water leaking. Can you tell me when someone can come and what the callout includes?” Replace those observations with your own.

Mention whether the main valve has been closed, the kind of property, and any access limits. If safe, take wide photos of the affected area before cleanup and share them through the channel the plumber or insurer requests. Keep urgent isolation ahead of documentation.

Separate emergency work from a lasting repair

Ask whether the visit is for isolation, finding the damaged line, a temporary repair or a complete repair. A dispatcher may be able to quote a minimum callout and explain the next approval step, while the actual scope depends on access. Ask who will explain the cost before opening finishes or replacing a longer run.

For a pipe that froze in an unheated corner, ask what made it vulnerable and what is included to prevent a repeat. A quote might cover a new section of pipe without work on the adjoining cabinet, wall or insulation. If two companies quote different outcomes, ask each to state who is responsible for access, protection, testing and restoration.

Ask for a short handover with the shutoff location, what was repaired, and any preventive work still due. The plumbing quote comparison guide can help when secondary work involves two trades. Keep the emergency number and shutoff description accessible for whoever looks after the property during the next cold spell.

Ask how to prevent the next freeze

Ask the plumber to identify which part of the building exposed the line and whether the quote includes only the pipe repair or insulation, air-sealing or changes to routing. Clarify who opens and restores walls. For a building with multiple units, ask who will check neighbouring rooms or shared areas for water damage.

Use the maintenance checklist to mark the shutoff location and pre-winter checks. Browse the PlumberPick directory when you need someone to inspect the line.